Seg Fault using argbatch

Was getting a stack trace after executing argbatch when I had Tamino installed on RedHat 7.2. Then, my REGFILE got corrupted. I installed update over the top of it hoping it would fix my seg fault as well , no such luck.

I am only trying to execute the argbatch command by itself, no params. Any ideas. Stack trace attached.


Don Shanks, CSI/UW
argbatch.segfault.dump (13.7 KB)

Hello Don,

Iā€™m not sure if this is a red herring or not, but perhaps the information provided by Bill in this posting: argbatch (backup database) is relevant to you.

It is certainly worth contacting the Customer Support Center.