Siebel adapter config problem

, ,
1

I am trying to configure the Siebel Adapter6.0 in the IS6.1. The parameters, which I have given to configure the Siebel Adapter, are correct. But when i try to enable the connection i am getting the following error:
“threw a SiebelException: code(4102), msg(Could not open a session in 4 attempts. {1}”
I am trying to connect to Siebel 7.5.3.
Any one even faced this issue before?

2

Hi,

IS 6.1 is having some problem. you need to apply patch for the same.

regards,
Saravanan.E

3

I have resolved this problem, thx!

4

prajno,

If you do not mind, can you post the solution also. So that anyone searching the form next time for same problem, is not disappointed by not finding the solution in here.

Regards
Ashok

5

prajno,

If you do not mind, can you post the solution also. So that anyone searching the forum next time for same problem, is not disappointed by not finding the solution in here.

Regards
Ashok